: How to create own bleed markings to cut after printing? We are making PDFs/EPS files to print. If we needed to make a crop mark to cut, we made small 90 degree angles from lines in the

@Debbie163

Just a reminder.

Remember to leave a space so the crop mark does not show. For some business cards can be 2mm, for some flyers can be lets say 3mm.

But for binded magazines you probably need more, depending on the binding technique. Probably 5mm.

For a large billboard can be for example 2 cm width.
otake.com.mx/Foros/CropMarks-01.png

Vote Up Vote Down

@Twilah924

It might require some crafty planning (see below), but you could create a custom Pattern Brush to use for this case.

Steps:


Create your custom crop mark, make a Swatch out of it
Create another swatch of a white line (this step is skipped in the demo below).
Create a new Pattern Brush, set the Outer Corner Tile as your custom crop mark, set the Side Tile as your white line
Apply the pattern brush to any rectangle to use it


Demo



Here's the result applied to a simple grey rectangle, use your imagination to replace that with your artwork:



Crafty Planning

The custom Pattern Brush is going to be centered on the rectangle's path, so you need to compensate for that with a bounding box when designing the crop mark in Step 1. If you divide my custom crop mark into four quadrants (guides denote center-lines), only the bottom right quadrant will be covered by the artwork.



So you need to create a bounding box 4x the size of the crop mark you want then place it within the lower right corner of the bounding box. In this example I shaded the bounding box with a lighter gray so you can see what I mean.

Vote Up Vote Down