: Transparent to black gradient? I am trying to recreate the effect on the bottom of this photograph, where it reads "Back from the Darkness". I have the text figured out as far as transforming

@Alves566

Buddy I hate to be the bearer of bad news but there's a gradient around that image giving it the black around the border but there is no gradient on the text its all the same shade of black.

C:75
M:68
Y:67
K:90

The only gradient is on the ground and edges. To do the ground the easiest way is to just use a very very large brush with that same blackness. I don't know your resolution but it should be about 1/5 the width of the image probably and then make it so that you have some extra space on your document layout and actually paint with the center of the brush off the page so only the edge touches. Do this on a new layer. After you lightly brush it grab the eraser tool and again on a very large size touch it up again using only the edge of the eraser. The center of the eraser should be towards the middle of the page at this point. Do not adjust the opacity at all because you want the darkest areas to have the same shade of black (listed above).

In the sample you did tinypic.com/view.php?pic=e85yzp&s=5 the brush is far too small and you didn't give it that nice little bit of curvature.

If you still have that image as a .psd and the gradient is on a separate layer you could skip the painting part and just grab a really big eraser and go to work on the top of the ground gradient and it would give you the same results.

Vote Up Vote Down

@Deb5748823

I'm not sure exactly what problem you're experiencing with your gradient, but you can achieve the black gradient 1 of 2 ways:


Create a layer above the background with a white-to-black gradient and blending mode set to "multiply".
Create a layer above the background with an all-black fill and a black-to-white gradient on the layer mask.


Both techniques above will yield very similar results. Here is a side-by-side of the 2 techniques over a generic texture:


After you get the gradient the way you like it, you'll may want to adjust it using Filter ⇒ Distort ⇒ Shear (you have to rotate your canvas first) to provide the arc that's present in the image you're replicating.

Edit:

The original has texture because the image you're trying to imitate starts its text much lower in the frame where there is more texture. Your image starts a bit higher where the texture is washed out. Also, I don't know what source image you're working with but it looks like your image was scaled-up. Scaling tends to reduce sharpness.

Here is a 3-up with the original photo, the target effect, and your attempt. The images have been scaled to make the tunnel as close to the same size as possible. Pay attention to the horizontal guides and where your gradient is positioned as opposed to where the other graphic's gradient is positioned.


(click for larger)

Source photo found here: dark.pozadia.org/wallpaper/Dark-Tunnel/

Vote Up Vote Down