: Way to make graphics on a convex car window appear straight? I'm designing a vinyl decal to cover the whole back window of a Jeep Cherokee. I got the dimensions from corner to corner, but

@Gonzalez368

I hope this isn't so dead that no one will notice but...

I agree with Vader, in my personal experience, this looks like it could have been partially fixed by proper application. If you notice there is space on the top corners but not the bottom. If the design was too small because the curvature of the window, there should have been space without vinyl on the window in all four corners. However, it does look like you did not give them enough extra space to play with. Therefore, it might have been a combination.

When beginning to design for vinyl, it's good to remember that vinyl does stretch. During application sometimes the design can be stretched into a direction that will make it look warped. Also, if there is not a lot of extra space, the person applying can't make sure the image lines up as needed, without worrying about running out of material. So, for instance, if the window was 4' long and 2.5' high, you would make the design that needs to be seen a little smaller than that but make the complete design larger. I would say 5' x 3.5'. This would allow the person to tack it down slowly, and in proper form, way over the surface parameters and make sure that it looked nice before taking a squeegee to it.

I would say if you looked up some videos on application and how its done correctly, that it would help you make the designs and also know when to take the blame for the design and when it could have been fixed by someone else.

I hope this helps as future reference.

-Zach C

Vote Up Vote Down

@Smith574

Many years ago we used to just take low tak masking tape generally around the size of the logo and place it on the back window and cut it out with an exacto knife and then remove it, lay it flat, and measure it to estimate the arc. Not seeing an example its going to be hard to give you a great answer but you could always do that as an option.

There are templates we used at a wrap shop that was just for Illustrator that has very good templates you might want to take a look at called Pro Vehicle Outlines. I recall they may have window measurements. It's been a couple of years but the site seems to have grown to what it used to be. If that doesn't work you could always look for window tint templates that usually configure the arch when die cutting tint on a plotter.

Other than those the only thing you can really do is test. Masking is somewhat cheap but I would suggest using scrap vinyl. We used to keep a huge bin of the stuff from die cut run for this very reason. They make great templates if you dont want to waste masking tape.



As stated you should still find a way to mask over the area. Maybe apply a flex ruler over the curved area and trace a line to find the exact curve you need to apply in your template or design file.

On another note, this is poor quality and I hope you didnt let this go out like this:




You should gently apply heat from a heat gun and use a covered squeegee and mold the vinyl around the button or whatever you call it. Let it dry then take a new exacto blade and trim coming at an angle parallel to the window itself. Not cutting at a 90 degree which is what it looks like you did. Not at all trying to be rude but if that is your work you should stand by it and if I was a customer I wouldn't take that I'd have you redo it.



After reading all the comments in a curved rear window you will not be able to have every design match or in your instance look perfectly straight. I would suggest possibly consulting with a local sign shop to see if they have templates or can assist you in targeting a design range for certain vehicles. In this situation I would provide three types of designs. One design for flat panel or truck rear windows that do not have a curve in the glass, a small arced window design for SUV windows that have an angle C/D pillar and a design for sedans that may need more of an extreme arc.

Vote Up Vote Down