: Even brightness in texture I have a floor tile texture I want to use in my bathroom Sketchup/Unity model (Its a photo I've taken of the actual tile). I have tried these two tutorials and

@Ann6370331

Duplicate your image layer (CtrlJ)
Invert the colors of the new layer (CtrlI)
Apply a Gaussian Blur filter (Filter > Blur > Gaussian Blur) and pick a radius that obscures all image details but isn't too high
Set the opacity of the new layer to 50% (50)
Flatten the image (CtrlShiftE)
Open the level adjustments menu (CtrlL)
Go to the Red channel (Alt3).
Drag the left handle so it's right below the left-most black pixel of the graph above it and do the same for the right handle and the right-most black pixel of the graph.
Repeat for the Green (Alt4) and Blue (Alt5) channels.
Hit OK. You're done!


You may want to adjust the lightness and saturation to fit your liking if it became slightly too light, dark, saturated, or desaturated.

Vote Up Vote Down

@Cugini998

This is more of a long comment and a tip than a answer

This is a pretty common 3D texture collecting problem. While Eddie A. describes works ill describe how to automate the finding of unevenness. As this becomes tedious with more complex textures.

The high pass you use kills some of the color variation which is bad. What you need is a low pass filtering, AKA Blur. By blurring the image so that no low level detail is available you get the overall color variation across the image. You can then go to LAB mode to get the inverse of lightness channel that you can use as a perfect mask in the color correction. This is like a manual high pass filtering that retains color better.

After this stage you may want to boost the effect with sharpen (the 3d render will blur images slightly) and paint the intersections after running offset to get it truly tile able.

Vote Up Vote Down

@Pierce403

I would add an adjustment level to the tile and then start painting a mask on the levels layer. Then select both of those layers (the tile, and adjustment) right click and convert to smart object. Then you transform it down and copy it so you can see how it looks edge to edge. You can then tweak this in almost realtime (after every save of the smart object) by having both the smart object open and then 4 tile pattern.

Mostly because you should do this on your own; You'll find a water mark on my attempt below.

Over all this will take a bit of time to get right.





You can see my mask here and layers for the single tile. I also added a black and white adjustment because there was some color variation in the stone.

Good Luck!

Vote Up Vote Down